Moog Videolarm QSDWT4-70NA5 Instrucciones de operaciones descargar pdf (Pagina 6)

- 6 -

CAMERA ADJUSTMENT

1. Access the cameras by removing the dome. Loosen the locking

screws on the lip of the dome. DO NOT TAKE THESE SCREWS

OUT. Once the screws are loosened, turn the dome counter

clockwise until it stops, then pull the dome off.

CAMERA FOCUSING (FOR EACH CAMERA)

Fixed Lens: Loosen the set screw in the lens mount. Manually

rotate the lens until a clear picture is achieved. Once

the focus is set, retighten the set screw (Figure 5).

Figure 5

Set screw

Fixed lens

Auto Iris Lens:

NOTE: THE AUTO IRIS LENS IS SET AT THE FACTORY.

• IF YOU EXPERIENCE VIDEO TOO LIGHT OR DARK

AUTO IRIS ADJUSTMENT MAY BE NEEDED.

SEE THE TROUBLESHOOTING SECTION FOR

ADJUSTMENT INFORMATION.

CAMERA SETTINGS

HIGH-RES BLACK & WHITE

FIXED AND FIXED VARI-FOCAL LENSES. There are no user

adjustable settings on these units (Figure 7).

Figure 7

AUTO IRIS LENSES. The dip switches are factory set with AES

off and backlight compensation on (Figure 8). The auto iris is also

set at the factory, but an adjustment screw is included for use if

needed. See page 10 for instructions on adjusting Auto Iris.

Auto Iris

adjustment

screw

AES Default Off

Backlight

Compensation

Default On

Figure 8

BW Fixed and Vari-Focal

BW Auto Iris

NOTE: To determine which camera is used in your unit, locate the

serial number on the inside of the housing. Match the two

letter preﬁx with the corresponding instructions included

here for adjustments.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Moog Videolarm QSDWT4-70NA5 Instrucciones de operaciones Pagina 6